TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 1206 of 1258
TM 9-2320-280-34 Section II ILLUSTRATED MANUFACTURING INSTRUCTIONS (Contd) INSTALLATION INSTRUCTIONS: NOTE Perform the engine removal procedures para 3-22 or 3-24 to a point prior to supporting transmission for engine removal. Perform steps 1 through 3 to secure transmission. 1. Position overhead support sling (2) on floor (3) and 'A" Frame (1). NOTE Use converter housing cover bolts to install transmission brackets on transmission housing. When performing step 2 it might be necessary to shift engine support chain link on L. H. eye bolt to adjust for securing transmission to transmission bracket. 2. Install transmission bracket (7) on transmission housing (4) with four existing bolts (5) and washers (6). 3. Tighten turn buckle (9) to remove slack from transmission chain (8). 4. Continue engine removal procedure para. 3-22 or 3-24. NOTE Perform transmission removal procedure para. 7-6 or 7-8 to point prior to supporting engine for transmission removal. Perform steps 5 through 8 to secure engine. 5. Position overhead support sling (2) on floor (3) and A"' frame (1). NOTE Use converter housing cover bolts and washers to install engine brackets on back of cylinder head. When performing step 6, it might be necessary to shift engine support chain link on L.H. eye bolt, to adjust for securing engine cylinder head to engine bracket. 6. Install engine brackets (10) to engine cylinder head (11) with two existing bolts (5) and washers (6). 7. Tighten turn buckle (9) to remove slack from engine bracket chains (8). 8. Continue transmission removal procedure para. 7-6 or 7-8. C-26