TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 1182 of 1258
TM 9-2320-280-34 Section II. ILLUSTRATED MANUFACTURING INSTRUCTIONS (Cont'd) Figure C-1. Differential Guide Pin, 5992390 INSTRUCTIONS: 1. Fabricate from screw, NSN 5305-00-709-8540. 2. Cut off head of screw. 3. Round off edge of non-threaded end as shown above. 4. Cut a slit approximately 1/16 in. wide and 1/8 in. deep in non-threaded end as shown above. 5. Remove any burrs after cutting. ' Figure C-2. Transmission Guide Pin, 5992391 INSTRUCTIONS: 1. Fabricate from screw, NSN 5306-00-226-4833. 2. Cut off head of screw. 3. Round off edge of non-threaded end as shown above. 4. Cut a slit approximately 1/16 in. wide and 1/8 in. deep in non-threaded end as shown above. 5. Remove any burrs after cutting. C-2