TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 118 of 1258
TM 9-2320-280-34 3-22. ENGINE REMOVAL (6.2 L) (Cont’d) NOTE Perform steps 35 through 48 for M997 and M997A1 vehicles only. 35. Remove screw (10) and clamp (11) from adjusting bracket (5). NOTE Prior to removal, tag leads for installation. 36. Disconnect two compressor leads (23) from two harness leads (24). 37. Remove nut (9), lockwasher (8), and washer (7) from adjusting bracket (5) and stud (2) on engine front cover (1). Discard lockwasher (8). 38. Remove two nuts (14), lockwashers (13), washers (12), capscrews (3), washers (4), and clamp (21) from adjusting bracket (5) and compressor (20). Discard lockwashers (13). 39. Remove adjusting bracket (5) and washer (6) from stud (2) on engine front cover (1). 40. Loosen two capscrews (17) securing compressor (20) to support bracket (22) and remove drivebelt (16) from pulley (15). 41. Loosen hose clamp (26) and disconnect hose (27) from surge tank (25). NOTE Place surge tank hose clear of compressor. 42. Disconnect vent line (31) from air cleaner fitting (32). 43. Disconnect vent line (28) from fitting (29) on air cleaner (30). 44. Remove two capscrews (17), lockwashers (18), and washers (19) from compressor (20) and support bracket (22). Discard lockwashers (18). CAUTION Be careful when removing compressor from support bracket, or damage to equipment may result. NOTE Place compressor and hoses on ground away from engine to prevent hang-ups during engine removal. 45. Remove compressor (20) from support bracket (22). 46. Remove capscrew (41) and brackets (22) and (43) from cylinder head (44). 47. Remove two nuts (39), lockwashers (38), washers (37), four clamps (35), and cables (36) from two studs (34). Discard lockwashers (38). 48. Remove two studs (34), washers (33), fuel line clamps (40), and brackets (22) and (43) from cylinder head (44) and engine block (42). 3-56