TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 1171 of 1258
TM 9-2320-280-34 22-10. AMBULANCE EXTERIOR BODY REPAIR (Cont'd) o. Right Rear/Lower/Upper body Panel Repair 1. Remove door weatherstrip (TM 9-2320-280-20). 2. Scribe two lines (7) centered over twenty-one rivets (3) and (5) on rear lower/upper body panel (1). J Extend scribed lines (7) a minimum of 1.00-in. (25.4 mm) onto body panels (4). 3. Using a 0.125-in. (3.175 mm) drill, remove ten rivets (3) from rear lower/upper body panel (1) and body panels (4). 4. Using a 0.187-in. (4.75 mm) drill, remove eleven rivets (5) from rear lower/upper body panel (1) and body panels (4). 5. Remove rear lower/upper body panel (1). 6. Remove adhesive residue and clean body panels (4). Do not remove scribed lines (7) marked in step 2. 7. Position rear lower/upper body panel (1) on body panels (4) and transfer scribed lines (7) marked in step 2. Remove rear lower/upper body panel (1). 8. Using scribed lines (7) marked in step 7, drill ten 0.125-in. (3.175 mm) diameter holes (9) in rear lower/upper body panel (1). 9. Using scribed lines (7) marked in step 7, drill eleven 0.187-in. diameter holes (8) in rear lower/upper body panel (1). 10. Apply approximately 0.125-in. (3.175 mm) thickness of adhesive sealant to rear lower/upper body panel (1) and body panels (4). 11. Install rear lower/upper body panel (1) on body panels (4) with ten rivets (2) and eleven rivets (6). 12. Spot paint rear lower/upper body panel (1) and body panels (4) (TM 43-0139). 13. Apply wicking sealant to eleven rivet heads (6) installed in step 11. 14. Install door weatherstrip (TM 9-2320-280-20). 22-42