TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download

Page 1129 of 1258

22-9.5. RIGHT REAR FLOOR PANEL REPAIR (Cont’d) TM 9-2320-280-34 22-16.76 Change 1 1. Cut two metal strips (1) from sheet metal, and mark two reference lines (2), centerline (3), and directional arrow (4), and identify as metal strips C and D. 2. Locate, mark, and drill twenty 0.187-in. diameter holes through metal strip C (1). 3. Bend metal strip C (1) 1.50 in. 4. Place metal strip D (1), on a suitable work surface, with arrow facing up and to the left. 5. Locate, mark, and drill twenty 0.187-in. diameter holes through metal strip D (1). 6. Bend metal strip D (1) 1.50 in. c. Metal Strips Fabrication