TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 1127 of 1258
22-9.5. RIGHT REAR FLOOR PANEL REPAIR (Cont’d) TM 9-2320-280-34 22-16.74 Change 1 1. Cut reinforcement strip (1) from sheet metal, and mark four reference lines (2), centerline (3), and identify as A on reinforcement strip (1). 2. Locate, mark, and drill twenty-one 0.187-in. diameter holes and a 0.750-in. diameter hole through reinforcement strip A (1). 3. Remove all burrs and round sharp edges of reinforcement strip A (1). 4. Cut reinforcement strip (4) from sheet metal, and mark four reference lines (5) and centerline (6). Identify reinforcement strip (1) as B. 5. Locate, mark, and drill eighteen 0.187-in. diameter holes and a 0.500-in. diameter hole through reinforcement strip B (4). 6. Remove all burrs and round sharp edges of reinforcement strip B (4). b. Reinforcement Strips Fabrication