TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 112 of 1258
TM 9-2320-280-34 3 - 22. ENGINE REMOVAL (6.2L) (Cont’d) 9. Remove four screws (18) and connector receptacle (19) from bracket (17). 10. Loosen rear receptacle cover (20) and slide wires of receptacle (19) out through slot in bracket (17). 11. Remove nut and lockwasher assembly (24), screw (22), and harness and clamp (23) from left splash shield (7). Discard nut and lockwasher assembly (24). 12. Remove locknut (21), washer (14), capscrew (15), washer (14), and left splash shield (7) from support bracket (16). Discard locknut (21). NOTE Early production vehicles used studs to connect splash shields to airlift brackets. 13. Remove locknut (2), washer (3), washer (4), capscrew (11), and washer (3) from left splash shield (7) and airlift bracket (1). Discard locknut (2). 14. Remove capscrew (12), lockwasher (13), and left splash shield (7) from airlift bracket (1). Discard lockwasher (13). 15. Remove locknut (5), washer (6), capscrew (10), washer (9), and left splash shield (7) from bracket (8). Discard locknut (5). 16. Remove locknut (30), two washers (29), capscrew (31), and right splash shield (39) from support bracket (28). Discard locknut (30). 17. Remove locknut (32), washer (33), washer (34), capscrew (35), and washer (33) from right splash shield (39) and airlift bracket (1). Discard locknut (32). 18. Remove locknut (37), washer (36), capscrew (25), and fuel line clamp (38) from right splash shield (39). Discard locknut (37). 19. Remove screw (27), lockwasher (26), and right splash shield (39) from airlift bracket (1). Discard lockwasher (26) 3-50