TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 1039 of 1258
TM 9-2320-280-34 22 - 3. BODY MOUNT REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: Tools Equipment Condition General mechanic's tool kit: Hood raised and secured (front mounts only) automotive (Appendix G, Item 1) (TM 9-2320-280-10). Materials/Parts Maintenance Level Locknut (Appendix E, Item 62) General support Manual References TM 9-2320-280-10 TM 9-2320-280-24P NOTE Removal and installation procedures for intermediate and rear body mounts are identical. On front body mounts, capscrew is inserted down through upper cushion. This procedure covers the left intermediate body mount. a. Removal 1. Remove locknut (2), washer (1), capscrew (7), washer (8), and spacer (9) from sleeve (4), upper cushion (5), lower cushion (10), body bracket (3), and frame bracket (6). Discard locknut (2). 2. Place jack under body reinforcements adjacent to body mount to be removed. 3. Raise the body far enough to separate the upper cushion (5) from lower cushion (10) and remove sleeve (4), upper cushion (5), and lower cushion (10). b. Installation 1. Install lower cushion (10), sleeve (4), and upper cushion (5) between body bracket (3) and frame bracket (6). 2. Lower body and align lower cushion (10), sleeve (4), upper cushion (5), and body bracket (3). Install with spacer (9), washer (8), capscrew (7), washer (1), and locknut (2). Tighten locknut (2) to 90 lb-ft (122 N.m). 22-2