TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 1001 of 1258
19-3. DIFFERENTIAL REPAIR (Cont’d) 3. Inspect splines and sealing surfaces on output flanges (1), pinion yoke (2), axle slinger (2.1), and output shafts (3) for damage. Replace if damaged. NOTE • If rear pinion yoke is being replaced, a new slinger must be installed on new pinion yoke. • Push rear pinion yoke into slinger until slinger is seated against rear shoulder of yoke. 4. Inspect all bearings (4) and bearing cups (5) for damage. Replace bearings (4) and bearing cups (5) in matched sets if either are damaged. 5. Inspect differential case (6) for damage. Replace if damaged. TM 9-2320-280-34 19-10 Change 1