TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download
Page 93 of 1170
TM 9-2320-280-20-3 I 10-47. SEATBELT ASSEMBLY REPLACEMENT I This task covers: a Removal b. Installation INITIAL SETUP: Tools Equipment Condition General mechanic’s tool kit ● Passenger seat back removed, rear seatbelt only (para. 10-45). automotive (Appendix B, Item 1) ● Companion seat and battery box cover removed, Manual References companion seatbelt only (para- 10-35). TM 9-2320-280-24P General Safety Instructions Seatbelts are to be replaced as a set. WARNING Seatbelts are to be replaced as a set. Failure to do this may cause injury to personnel or damage to equipment. NOTE ● This procedure applies to all vehicles with serial numbers USBL Eff. 99,999 and below. ● All seatbelt removal and installation procedures are basically the same. This procedure covers the driver’s seatbelt. 1. Remove anchor bolt (8), buckle assembly (7), and washer (6) from bracket (5). 2. Remove anchor bolt (4), connector assembly (3), and washer (2) from body (1). I b. Installation 1. Install washer (2) and connector assembly (3) on body (1) with anchor bolt (4). Tighten anchor bolt (4) to 35-40 lb-ft (47-54 Nom). 2. Install washer (6) and buckle assembly (7) on bracket (5) with anchor bolt (8). Tighten anchor bolt (8) to 35-40 lb-ft (47-54 Nom). FOLLOW-ON TASKS: . Install passenger seat back, rear seatbelt only (Pam. 10-45). ● Install companion seal battery box cover, companion seatbelt only (para. 10-35). 10-75