TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download
Page 909 of 1170
1. Remove three locknuts (9), six washers (2), three capscrews (7), and front skid plate (6) from front shield (8). Discard locknuts (9). 2. Remove three locknuts (5), six washers (3), three capscrews (4), and front skid plate (6) from front bumper (1). Discard locknuts (5). a. Front Skid Plate Removal INITIAL SETUP: TM 9-2320-280-20-3 12-296 Change 2 12-186. UNDERBODY PROTECTION KIT REPLACEMENT Applicable Models M997A2, M1025A2, M1035A2, M1043A2, M1045A2, M1097A2, M1123 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Four flat washers (Appendix G, Item 36) Twenty-five locknuts (Appendix G, Item 128) Two locknuts (Appendix G, Item 81) Seventeen locknuts (Appendix G, Item 79) Manual References TM 9-2320-280-10 TM 9-2320-280-24P General Safety Instructions • Do not perform this procedure near fire, flames or sparks. • Fuel tank must be supported during removal and installation. This task covers: a. Front Skid Plate Removal g. Fuel Tank Shield Installation b. Front Shield Removal h. Rear Shield Installation c. Intermediate Shield Removal i. Transfer Case Shield Installation d. Transfer Case Shield Removal j. Intermediate Shield Installation e. Rear Shield Removal k. Front Shield Installation f. Fuel Tank Shield Removal l. Front Skid Plate Installation