TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download
Page 788 of 1170
12-119. TROOP/CARGO WINTERIZATION TOP COVER ASSEMBLY REPLACEMENT (Cont'd) 1. Apply adhesive spray to channel (3) and mating surfaces of two rubber strips (2) and install rubber strips (2) on channel (3). 2. Apply adhesive spray to outside corner plates (4) and mating surfaces of two seals (1) and install seals (1) on outside corner plates (4). 3. Apply adhesive spray to two rear end closure assemblies (6) and mating surfaces of rubber strips (5) and install rubber strips (5) on rear end closure assembly (6). 4. Apply adhesive spray to right side of vehicle (8) and mating surface of rubber strip (7) and install rubber strip (7) on right side of vehicle (8). 5. Apply adhesive spray to left side of vehicle (10) and mating surface of rubber strip (9) and install rubber strip (9) on left side of vehicle (10). 6. Apply an even coat of sealant to two top enclosure assemblies (13), rear end closure assemblies (17), corner edges (19), and other shaded areas. 7. Apply sealant to top enclosure assembly clamps (11), plates (14), and screws (12). NOTE If raised edges or gaps exist around areas of outside corner plates and rear end closure assembly, fill with sealant. 8. Apply sealant to outside corner plates (15) and channel assembly (16). 9. Apply sealant to any open gaps on rear end closure assembly (17) and vehicle body (18). b. Installation TM 9-2320-280-20-3 12-182 Change 2