TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download
Page 574 of 1170
TM 9-2320-280-20-3 11-205. AIR INTAKE FILTER MAINTENANCE This task covers Applicable Models M996, M996A1, M997, M997A1, M997A2 Detergent (Appendix C, Item (17) Took Equipment Condition General mechanic’s tool kit: Air intake filters removed (TM 9-2320-280-10). automotive (Appendix B, Item 1) General Safety Instructions Manual References . NBC contaminated filters must be handled and TM 9-2320-280-10 disposed of only by trained personnel. TM 9-2320-280-24P ● Compressed air used for cleaning purposes will FM 3-4 not exceed 30 psi (207 kPa). FM 3-5 WARNING NBC contaminated filters must be handled and disposed of only by authorized and trained personnel. The unit commander or senior officer in charge of maintenance personnel must ensure that prescribed protective clothing (FM 3-4) is used, and prescribed safety measures and decontamination procedures (FM 3-5) are followed. The local unit SOP is responsible for final disposal of contaminated air filters, Inspect filters (1) for tears, rips, contaminants, or other damage. Inspect filter frames (2) and supports (3) for cracks, bends, or other damage. If filters (1), frames (2), or support (3) are damaged, replace. 1. Cleaning with detergent. Remove oily dirt from filter (1) by gently hand washing in warm water and non-sudsing detergent. Gently rinse filter (1) with warm water. Allow filter to dry. 2. Cleaning with compressed air. WARNING Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa). Use only with effective chip guarding and personnel protective equipment (goggles/shield, gloves, etc.). Remove oily dirt and dust from filter (1) by directing air stream at an angle and approximately 6 in. (152.4 mm) from filter (1). Blow away loosened dirt or dust from both sides of filter (1). 11-310