TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download
Page 555 of 1170
TM 9-2320-280-20-3 11-197. BLOWER MOTOR RESISTOR REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: Applicable Models Equipment Condition M996, M996A1, M997, M997A1, M997A2 l Battery ground cable disconnected (para. 4-73). l Blower housing open (para. 11-198). Tools . Heater compartment panel removed General mechanic’s tool kit: (M996 and M996A1 vehicles only) (para. 11-204). automotive (Appendix B, Item 1) Manual References TM 9-2320-280-24P NOTE M996, M996A1, M997, M997A1, and M997A2 blower motor resistors are replaced basically the same. This procedure covers M997, M997A1, and M997A2 vehicles only. 1. Disconnect plug (1) from resistor (3). 2. Remove two screws (4) and resistor (3) from blower housing (2). 1. Install resistor (3) on blower housing (2) with two screws (4). 2. Connect plug (1) to resistor (3). FOLLOW-ON TASKS: l l l w Close blower housing (para. 11-198). Connect battery ground cable (para. 4-73). Heater compartment panel installed (M996 and M996A1 vehicles only) (para. 11-204). 11-291