TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download
Page 50 of 1170
10-20. ENGINE RIGHT SPLASH SHIELD MAINTENANCE This task covers: a. Removal c. Assembly b. Disassembly d. Installation a. Removal 1. Remove locknut (7), washer (6), capscrew (8), and washer (6) from splash shield (1) and support bracket (5). Discard locknut (7). 2. Remove locknut (15), washer (16), washer (17), capscrew (19), lockwasher (18), and washer (16) from splash shield (1) and airlift bracket (4). Discard locknut (15) and lockwasher (18). 3. Remove locknut (21), washer (20), capscrew (10), and fuel line clamp (22) from splash shield (1). Discard locknut (21). 4. Remove two screws (2), lockwashers (3), washers (9) (vehicles without armor plate), and splash shield (1) from airlift bracket (4). Discard lockwashers (3). NOTE Right splash shield maintenance is the same for all vehicles, except M998, M998A1, M1035, M1035A1, M1035A2, M1037, M1038, M1038A1, and M1042 vehicles do not have an armor plate attached to side of shield. INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Four locknuts (Appendix G, Item 79) Three lockwashers (Appendix G, Item 134) Seven locknuts (Appendix G, Item 107) Locknut (Appendix G, Item 70) Manual References TM 9-2320-280-10 TM 9-2320-280-24P Equipment Condition • Hood raised and secured (TM 9-2320-280-10). • 3.5-ton jack stowage bracket and cover removed (M1123 and “A2” series only) (para. 10-19). b. Disassembly 1. Remove locknut (14), washer (12), capscrew (11), washer (12), and support plate (13) from splash shield (1). Discard locknut (14). TM 9-2320-280-20-3 10-34 Change 2