TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download
Page 453 of 1170
TM 9-2320-280-20-3 11-134. REAR STEPS STRIKER AND BRACKET MAINTENANCE This task covers: a. Striker Removal d. Bracket Installation b. Striker Installation e. Bracket Adjustment c. Bracket Removal INITIAL SETUP: Applicable Models Manual References M996, M996A1, M997, M997A1, M997A2 TM 9-2320-280-10 TM 9-2320-280-24P Tools General mechanic’s tool kit: Equipment Condition automotive (Appendix B, Item 1) Rear steps lowered (TM 9-2320-280-10). Personnel Required One mechanic One assistant a. Striker Removal Remove striker (5) from bracket (4). b. Striker Installation Install striker (5) on bracket (4). Tighten striker (5) to 60 lb-ft (81 N.m). c. Bracket Removal Remove four capscrews (1), washers (2), and bracket (4) from body (3). d. Bracket Installation Install bracket (4) on body (3) with four capscrews (1) and washers (2). Do not tighten capscrews (1). I e. Bracket Adjustment 1. Loosen four capscrews (1) from bracket (4) and body (3) on opposite bracket (4) replaced. 2. Raise rear steps (TM 9-2320-280-10) and ensure rear step latches are engaged on strikers (5). 3. Press rear step assembly firmly against body (3), hold in place, and tighten eight capscrews (1) on two brackets (4) and body (3). 4. Lower rear steps (TM 9-2320-280-10). Tighten eight capscrews (1) to 6 lb-ft (8 N.m). 11-194