TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download
Page 449 of 1170
11-131. REAR DOOR LATCH ROD STRIKER GUIDES AND BRACKETS MAINTENANCE This task covers: a. Striker Guide Removal d. Bracket Installation b. Striker Guide Installation e. Striker Guide Adjustment c. Bracket Removal INITIAL SETUP: Applicable Models M996, M996A1, M997, M997A1, M997A2 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Three blind rivets (Appendix G, Item 259) Manual References TM 9-2320-280-10 TM 9-2320-280-24P Equipment Condition • Rear doors opened (TM 9-2320-280-10). • Rear door blackout switch bracket removed (para. 4-93). TM 9-2320-280-20-3 11-190 Change 2 NOTE Upper and lower striker guides and brackets are replaced basically the same. This procedure covers the upper striker guide and bracket. Remove two nuts (7), washers (5), screws (4), washers (5), and striker guide (6) from bracket (2). 1. Install striker guide (6) on bracket (2) with two washers (5), screws (4), washers (5), and nuts (7). Do not tighten nuts (7). 2. Proceed to Adjustment, e.2. NOTE For instructions on replacement of rivets, refer to para. 10-66. 1. Remove striker guide (step a. above). 2. Remove three rivets (3) and bracket (2) from body (1). 1. Install bracket (2) on body (1) with three rivets (3). 2. Install striker guide (step b. above). 1. Check all four striker guides (6) for proper clearance from latch rods (8). Clearance should be 1/8 in. (3 mm) from end of latch rods (8) to surface of striker guides (6). If clearance of any striker guide (6) is not within specifications, loosen two locknuts (7) from striker guide (6) and bracket (2). 2. Install striker guide (6) 1/8 in. (3 mm) from end of latch rod (8), hold in place, and tighten two nuts (7). e. Striker Guide Adjustment d. Bracket Installation c. Bracket Removal b. Striker Guide Installation a. Striker Guide Removal