TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download
Page 44 of 1170
10-17. ENGINE LEFT SPLASH SHIELD MAINTENANCE This task covers: a. Removal c. Assembly b. Disassembly d. Installation Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Seven locknuts (Appendix G, Item 107) Four lockwashers (Appendix G, Item 143) Assembled locknut (Appendix G, Item 131) Three locknuts (Appendix G, Item 79) Two locknuts (Appendix G, Item 70) Locknut (Appendix G, Item 128) Lockwasher (Appendix G, Item 134) Four rivets (Appendix G, Item 239) Manual References TM 9-2320-280-24P Equipment Condition • Battery ground cable disconnected (para. 4-73). • Hood prop rod and bracket removed (para. 10-4). General Safety Instructions Hood must be supported during removal and installation. WARNING Hood must be supported during removal and installation. Failure to support hood may cause injury to personnel and damage to equipment. NOTE • Left splash shield maintenance is the same for all vehicles, except M998, M998A1, M1035, M1035A1, M1035A2, M1037, M1038, M1038A1, and M1042 vehicles do not have an armor plate attached to side of shield. • The left splash shield can be modified with an access cover which will provide easier access to transmission oil cooler lines, at commander’s discretion. Refer to appendix D, Figs. D-86 and D-87. 1. Disconnect hood harness (27) from connector receptacle (30). 2. Remove locknut (3), washer (2), capscrew (24), and washer (2) from splash shield (15) and support bracket (1). Discard locknut (3). 3. Remove locknut (10), washer (11), washer (12), capscrew (20), and washer (11) from splash shield (15) and airlift bracket (9). Discard locknut (10). 4. Remove capscrew (21), lockwasher (22), and washer (23) from splash shield (15) and airlift bracket (9). Discard lockwasher (22). 5. Remove four screws (28) , lockwashers (29), and connector receptacle (30) from bracket (32). Discard lockwashers (29). 6. Remove assembled locknut (39) and screw (37) from harness and clamp (38) and splash shield (15).Discard assembled locknut (39). 7. Remove locknut (13), washer (14), capscrew (19), washer (14), and splash shield (15) from bracket (16). Discard locknut (13). NOTE Perform step 1 only if vehicle has an armor plate. 1. Remove locknut (33), washer (34), capscrew (36), washer (34), and armor plate (35) from splash shield (15). Discard locknut (31). b. Disassembly a. Removal TM 9-2320-280-20-3 10-28 Change 2