TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download

Page 429 of 1170

11-170 Change 2 TM 9-2320-280-20-3 11-121. SHELTER SUPPORT ASSEMBLY REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: Applicable Models M1037, M1042, M1097, M1097A1, M1097A2 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Locknut (Appendix G, Item 70) Thirteen locknuts (Appendix G, Item 81) Four locknuts (Appendix G, Item 128) Personnel Required One mechanic One assistant Manual References TM 9-2320-280-10 TM 9-2320-280-24P Equipment Condition • Shelter carrier tailgate brackets removed (para. 11-118). • Cab enclosure panels removed (para. 11-122). • Fuel filler housing removed (para. 10-2). • Rear soft top curtain rolled up (TM 9-2320-280- 10). • Shelter removed (para. 11-120). 1. Remove two locknuts (24), washers (2), capscrews (4), washers (5), and spacers (6) from support assembly (27) and cargo floor (22). Discard locknuts (24) 2. Remove six locknuts (24), washers (2), reinforcement plates (23) and (25), six capscrews (3), washers (2), and spacers (1) from support assembly (27) and “B” beam (26). Discard locknuts (24). 3. Remove two locknuts (21), washers (7), capscrews (9), and washers (10) from support assembly (27) and cargo floor (22). Discard locknuts (21). 4. Remove locknut (34), washer (33), capscrew (29), washer (30), clamp (32), and fuel filler spout (28) from body (31) and pull fuel filler spout (28) away for access to locknut (21). Discard locknut (34). 5. Remove two locknuts (21), washers (7), capscrews (8), and washers (7) from support assembly (27) and cargo floor (22). Discard locknuts (21). 6. Remove four locknuts (19), washers (14), capscrews (13), and washers (14) from support assembly and cargo floor (22). Discard locknuts (19). 7. Remove three nuts (20), washers (15), capscrews (16), and washers (15) from support assembly (27) and “D” beam (17). 8. Remove locknut (18), washer (12), capscrew (11), washer (12), and support assembly (27) from cargo floor (22) and “D” beam (17). Discard locknut (18). 1. Install support assembly (27) on cargo floor (22) and “D” beam (17) with washer (12), capscrew (11), washer (12), and locknut (18). 2. Secure support assembly (27) to “D” beam (17) with three washers (15), capscrews (16), washers (15), and nuts (20). 3. Secure support assembly (27) to cargo floor (22) with four washers (14), capscrews (13), washers (14), and locknuts (19). 4. Secure support assembly (27) to cargo floor (22) with two washers (7), capscrews (8), washers (7), and locknuts (21). 5. Install support assembly (27) on “B” beam (26) with six spacers (1), washers (2), capscrews (3), two reinforcement plates (23) and (25), six washers (2), and locknuts (24). b. Installation a. Removal