TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download
Page 386 of 1170
11-93. RIFLE MOUNTING CLAMP BRACKET REPLACEMENT (M16 A1 RIFLE/M203 GRENADE LAUNCHER) This task covers: a. Removal b. Installation a. Removal 1. Remove cotter pin (7) from handle (5). Discard cotter pin (7). 2. Remove handle (5), lockwasher (4), washer (3), and clamp bracket (2) from mounting bracket (6). Discard lockwasher (4). 3. Remove two locknuts (10), washers (8), capscrews (9), washers (8), and mounting bracket (6) from “A” beam (1). Discard locknuts (10). NOTE Replacement procedures for left and right rifle mounting clamp brackets are basically the same. This procedure covers the right rifle mounting clamp bracket. INITIAL SETUP: Applicable Models All models except M996, M996A1, M997, M997A1, M997A2, M998, M998A1, M1035, M1035A1, M1035A2, M1037, M1038, M1038A1, M1042, M1097, M1097A1, M1097A2 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Cotter pin (Appendix G, Item 24) Lockwasher (Appendix G, Item 135) Two locknuts (Appendix G, Item 70) Manual References TM 9-2320-280-24P Equipment Condition Rifle mounting clamp removed (para. 11-91). b. Installation 1. Install mounting bracket (6) on “A” beam (1) with two washers (8), capscrews (9), washers (8), and locknuts (10). 2. Install clamp bracket (2) on mounting bracket (6) with washer (3), lockwasher (4), and handle (5). 3. Install cotter pin (7) on handle (5). FOLLOW-ON TASK: Install rifle mounting clamp (para. 11-91). TM 9-2320-280-20-3 Change 2 11-135