TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download
Page 384 of 1170
11-92. RIFLE MOUNTING CLAMP BRACKET REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: Applicable Models All models except M996, M996A1, M997, M997A1, M997A2, M998, M998A1, M1035, M1035A1, M1035A2, M1037, M1038, M1038A1, M1042, M1097, M1097A1, M1097A2, M1123 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Two locknuts (Appendix G, Item 70) Two locknuts (Appendix G, Item 122) Manual References TM 9-2320-280-24P Equipment Condition Rifle mounting clamp removed (para. 11-91). NOTE Replacement procedures for the front and rear (rear bracket installed on M1025, M1025A1, M1025A2, M1026, M1026A1, M1043, M1043A1, M1043A2, M1044, and M1044A1 vehicles only) rifle mounting clamp brackets are basically the same. This procedure covers the right front and right rear bracket (M1025A2 only). 1. Remove two locknuts (5), washers (3), capscrews (4), washers (3), and clamp bracket (2) from “A” beam (1). Discard locknuts (5). NOTE Perform step 2 for M1025A2 vehicles only. 2. Remove two locknuts (6), washers (7), capscrews (9), washers (7), and clamp bracket (8) from “B” pillar (10). Discard locknuts (6). 1. Install clamp bracket (2) on “A” beam (1) with two washers (3), capscrews (4), washers (3), and locknuts (5). NOTE Perform step 2 for M1025A2 vehicles only. 2. Install clamp bracket (8) on “B” pillar (10) with two washers (7), capscrews (9), washers (7), and locknuts (6). b. Installation a. Removal TM 9-2320-280-20-3 11-134 Change 2