TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download
Page 383 of 1170
11-91. RIFLE MOUNTING CLAMP REPLACEMENT This task covers: a. Removal b. Installation a. Removal Remove two locknuts (2), washers (3), screws (4), washers (3), and clamp (5) from clamp bracket (1). Discard locknuts (2). INITIAL SETUP: Applicable Models All models except M996, M996A1, M997, M997A1, M997A2, M998, M998A1, M1035, M1035A1, M1035A2, M1037, M1038, M1038A1, M1042, M1097, M1097A1, M1097A2, M1123 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Two locknuts (Appendix G, Item 91) Two locknuts (new configuration) (Appendix G, Item 92) Manual References TM 9-2320-280-24P b. Installation Install clamp (5) on clamp bracket (1), with moveable finger (6) inboard, with two washers (3), screws (4), washers (3), and locknuts (2). NOTE • Procedures for replacing the left and right rifle mounting clamps are basically the same. This procedure covers the right rifle mounting clamp. • Vehicle may be equipped with new rifle mounting clamp bracket configuration for M16 rifle or M203 grenade launcher. TM 9-2320-280-20-3 Change 2 11-133