TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download

Page 371 of 1170

11-79. TRIPOD HEAD MOUNTING BRACKET REPLACEMENT This task covers: a. Removal b. Installation a. Removal 1. Remove three locknuts (7), washers (6), and plate assembly (5) from wheelhouse (8). Discard locknuts (7). 2. Remove three capscrews (1), washers (2), tripod head bracket (3), and three spacers (4) from wheelhouse (8) NOTE On M1045, M1045A1, M1045A2, M1046, and M1046A1 models, there is an additional washer between the wheelhouse and the wheelhouse armor. INITIAL SETUP: Applicable Models M966, M966A1, M1036, M1045, M1045A1, M1045A2, M1046, M1046A1 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Three locknuts (Appendix G, Item 70) Manual References TM 9-2320-280-10 TM 9-2320-280-24P Equipment Condition • Rear end of cargo shell door raised (TM 9-2320-280-10). • Tailgate lowered (TM 9-2320-280-10). b. Installation 1. Install three spacers (4) and tripod head bracket (3) on wheelhouse (8) with three washers (2) and capscrews (1). 2. Install plate assembly (5) on wheelhouse (8) with three washers (6) and locknuts (7). Tighten locknuts (7) to 6 lb-ft (8 Nm). FOLLOW-ON TASKS: • Raise and secure tailgate (TM 9-2320-280-10). • Close cargo shell door (TM 9-2320-280-10). TM 9-2320-280-20-3 Change 2 11-121