TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download
Page 354 of 1170
11-73. ELEVATION AND DEPRESSION STOP ASSEMBLY MAINTENANCE This task covers: a. Disassembly b. Assembly a. Disassembly 1. Remove retaining ring (3), clevis pin (15), cable end of pin assembly (14), and return spring (1) from upward stop strap (4). Discard retaining ring (3). 2. Remove pin assembly (14) and upward stop bracket (2) from upward stop strap (4). 3. Remove retaining ring (6), clevis pin (9), cable end of pin assembly (10), and return spring (8) from downward stop strap (11). Discard retaining ring (6). 4. Remove pin assembly (10) and downward stop bracket (7) from downward stop strap (11). 5. Remove retaining ring (16), clevis pin (5), socket head screw (12), and washer (13) from stop straps (4) and (11). Discard retaining ring (16). INITIAL SETUP: Applicable Models M966, M966A1, M1036, M1045, M1045A1, M1045A2, M1046, M1046A1 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Three retaining rings (Appendix G, Item 235) Manual References TM 9-2320-280-24P General Safety Instructions Note position of downward stop and upward stop for assembly. b. Assembly 1. Install stop straps (4) and (11) together with clevis pin (5), retaining ring (16), washer (13), and socket head screw (12). 2. Install downward stop bracket (7) on downward stop strap (11) with pin assembly (10) through upper holes of downward stop bracket (7) and downward stop strap (11). 3. Install return spring (8), downward stop bracket (7), and cable end of pin assembly (10) on downward stop strap (11) with clevis pin (9) and retaining ring (6). 4. Install upward stop bracket (2) on upward stop strap (4) with pin assembly (14) through upper holes of upward stop bracket (2) and upward stop strap (4). 5. Install return spring (1), upward stop bracket (2), and cable end of pin assembly (14) on upward stop strap (4) with clevis pin (15) and retaining ring (3). WARNING Note position of elevation and depression downward stop and upward stop for assembly. Injury to personnel and/or damage to equipment will result if stops are not properly assembled. TM 9-2320-280-20-3 11-104 Change 2