TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download
Page 350 of 1170
11-70. STOWAGE MOUNT BRACKET REPLACEMENT This task covers: a. Removal b. Installation a. Removal 1. Remove two locknuts (5), washers (4), capscrews (17), and washers (4) from stowage mount bracket (3) and support bracket (12). Discard locknuts (5). 2. Remove capscrew (8), washer (9), and tiedown (10) from stowage bracket (3) and cargo floor (16). 3. Slide plate (18) in “B” beam (14) to allow access to nut (13). 4. Remove nut (13), capscrew (6), and washer (7) from stowage bracket (3), spacer (11), and cargo floor (16). 5. Remove nut (15), capscrew (2), washer (1), stowage bracket (3), and spacer (11) from cargo floor (16). INITIAL SETUP: Applicable Models M966, M966A1, M1036, M1045, M1045A1, M1045A2, M1046, M1046A1 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Two locknuts (Appendix G, Item 70) Personnel Required One mechanic One assistant Manual References TM 9-2320-280-24P Equipment Condition • Stowage pedestal removed (para. 11-71). • Fuel tank removed (para. 3-24). b. Installation 1. Install spacer (11) and stowage bracket (3) on cargo floor (16) with washer (1), capscrew (2), and nut (15). Tighten capscrew (2) to 37 lb-ft (50 N•m). 2. Install stowage bracket (3) on cargo floor (16) with washer (7), capscrew (6), and nut (13). Tighten capscrew (6) to 37 lb-ft (50 N•m). 3. Close plate (18) in “B” beam (14). 4. Secure stowage bracket (3) and tiedown (10) to cargo floor (16) with washer (9) and capscrew (8). Tighten capscrew (8) to 75 lb-ft (102 N•m). 5. Install stowage bracket (3) on support bracket (12) with two washers (4), capscrews (17), washers (4), and locknuts (5). Tighten locknuts (5) to 6 lb-ft (8 N•m). TM 9-2320-280-20-3 11-100 Change 2