TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download
Page 327 of 1170
11-56. TURRET LOCK REPLACEMENT This task covers: a. Removal b. Installation a. Removal Remove two locknuts (6), washers (1), capscrews (2), washers (1), turret lock (5), and spacer(s) (4) from weapon station (3). Discard locknuts (6). INITIAL SETUP: Applicable Models All models except M996, M996A1, M997, M997A1, M997A2, M998, M998A1, M1035, M1035A1, M1035A2, M1037, M1038, M1038A1, M1042, M1097, M1097A1, M1097A2 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Two locknuts (Appendix G, Item 128) Manual References TM 9-2320-280-24P b. Installation Install spacer(s) (4) and turret lock (5) on weapon station (3) with two washers (1), capscrews (2), washers (1), and locknuts (6). Tighten locknuts (6) to 37 lb-ft (50 N•m). NOTE Install same amount of spacers that were removed between bottom of weapon station and turret lock. Amount of spacers may be adjusted to correct lock handle binding. Refer to TM 9-2320-280- 24P if more spacers are needed. TM 9-2320-280-20-3 Change 2 11-77