TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download
Page 321 of 1170
TM 9-2320-280-20-3 11-50. WEAPON STATION HATCH LATCH REPLACEMENT This task covers: a. Removal b. Installation lNITIAL SETUP: Applicable Models Tools All models except M996, M996A1, M997, General mechanic’s tool kit M997A1, M997A2, M998, M998A1, M1035, automotive (Appendix B, Item 1) M1035A1, M1035A2, M1037, M1038, M1038A1, M1042, M1097, M1097A1, M1097A2 Manual References TM 9-2320-280-24P NOTE ● Procedures for replacing the three hatch latches are basically the same, except the hatch latch opposite the backrest side of weapon station has a spacer. This procedure covers the hatch latch with spacer. ● To increase latch tension, 3/8-in. (9.5 mm) flat washers may be added between bottom of weapon station and any of the three hatch latches. Remove capscrew (2), washer(1), hatch latch (5), and spacer (4) from weapon station (3). Install spacer (4) and hatch latch (5) on weapon station (3) with washer (1) and capscrew (2). Tighten capscrew (2) to 37 lb-ft (50 N-m). 11-71