TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download
Page 259 of 1170
Applicable Models All models except M998, M998A1, M1035, M1035A1, M1035A2, M1037, M1038, M1038A1, M1042, M1097, M1097A1, M1097A2 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Tape (Appendix C, Item 50) Two locknuts (Appendix G, Item 86) Manual References TM 9-2320-280-24P 11-5. BALLISTIC CREW DOOR FRONT STRIKER PLATE MAINTENANCE This task covers: a. Removal c. Adjustment b. Installation INITIAL SETUP: Remove two locknuts (5), door strap (4), two capscrews (1), and front striker plate (2) from “B” pillar (3). Discard locknuts (5). Remove tape from front striker plate (2) and discard tape. Apply tape to front striker plate (2) mounting surface. Install front striker plate (2) on “B” pillar (3) with two capscrews (1), door strap (4), and two locknuts (5). Finger tighten locknuts (5). 1. Close door (6) ensuring latch (7) latches on front striker plate (2). NOTE Front striker plates are slotted for vertical adjustment. 2. Press crew door (6) slightly inward and upward until seal (9) contacts body (8). Tighten locknuts (5) to 19 lb-ft (26 N•m). 3. Open and close crew door (6) several times to ensure proper latch (7) and front striker plate (2) alignment. If front striker plate (2) cannot be adjusted to align with latch (7), adjust crew door (6) (para. 11-2). c. Adjustment b. Installation a. Removal TM 9-2320-280-20-3 11-10 Change 2