TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download
Page 135 of 1170
TM 9-2320-280-20-3 10-68. M11 DECONTAMINATION BRACKETS INSTALLATION (Cont’d) 5. 6. 7. 8. 9. 10. NOTE Perform steps 5 through 10 for models M1025, M1025A1, M1025A2, M1026, and M1026A1 vehicles only. Using bracket (17) as a template, locate, mark, and drill a 0.281-inch (7.14 mm) diameter hole (22) through armor panel (13) and left wheel housing (25). Install bracket (17) on armor panel (13) and left wheel housing (25) with washer (21), screw (20), washer (21), and nut (24). Do not tighten nut (24). Position M11 decontaminating apparatus (19) in bracket (17) with handle (18) toward rear of vehicle. Place top of M11 decontaminating apparatus (19) and bracket (17) between rear seat (16) and M13 decontamination mount bracket (23) in an upright position. Using bracket (17) as a template, scribe a reference line (14) on armor panel (13). Remove M11 decontaminating apparatus (19) from bracket (17). Using marked reference line (14) on armor panel (13) and bracket (17) as a template, locate, mark, and drill two 0.281-inch (7.14mm) diameter holes (15). Install bracket (17) on armor panel (13) with two washers (21), screws (20), washers (21), and nuts (24). Tighten screw (20) and nut (24) installed in step 6. 10-113