TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download
Page 1080 of 1170
TM 9-2320-280-20-3 Change 1 D-107 Section II. ILLUSTRATED MANUFACTURING INSTRUCTIONS (Cont'd) INSTRUCTIONS (CONT’D): 34. Cut electrical wire (2) to length as shown. 35. Connect two terminal lugs (1) on wire (2). 36. Install wire (2) and tip jack lead (3) marked 5 on mount hole (10) on mini-box bottom section (9) with washer (11), screw (7), and nut (8). 37. Connect wire (2) to terminal strip (4) marked D with screw (5). 38. Connect tip jack lead (3) marked 1 to terminal strip (6) marked H with screw (5). 39. Connect tip jack lead (3) marked 3 to terminal strip (6) marked B with screw (5). 40. Connect tip jack lead (3) marked 4 to terminal strip (6) marked C with screw (5). 41. Connect tip jack lead (3) marked 6 to terminal strip (6) marked A with screw (5). 42. Using existing drive pin, punch out four screw mount holes (14) in mini-box top section (12). 43. Install plug (16) and connector (15) as shown. 44. Install mini-box top (12) on bottom section (9) with four existing screws (13). Figure D-113. Test Module Assembly (Cont’d).