TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download

Page 1071 of 1170

TM 9-2320-280-20-3 D-98 Change 1 Section II. ILLUSTRATED MANUFACTURING INSTRUCTIONS (Cont'd) Figure D-110. Mini-box Top Section Drill Procedure (Cont’d). INSTRUCTIONS (CONT’D): 4. Using data mark set, mark location of thirteen holes (1) on mini-box top section (3). 5. Using data mark set, mark location of six holes (9) on mini-box top section (3). 6. Install tip jack (10) and nut (8) in hole (9) marked 2 on mini-box top section (3). 7. Install five tip jacks (4) with wires (5) and nuts (6) in holes (9) marked 1, 3, 4, 5, and 6 on mini-box top section (3). 8. Install five terminal lugs (7) to wires (5) on tip jacks (4). 9. Install thirteen LEDs (2) in holes (1) marked 1 through 13 on mini-box top section (3). 10. Cut electrical insulation sleeving (13) into twenty-five sections as shown. 11. Place twelve sections of electrical insulation sleeving (13) over red (+) wires (11) marked 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, and 13 on LEDs (2). 12. Place thirteen sections of electrical insulation sleeving (13) over black (–) wires (12) marked 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, and 13 on LEDs (2). ITEM MATERIALS NO. REQ’D DESCRIPTION NSN 1 Data Mark Set 7510-01-040-7110 1 Data Mark Set 7510-01-158-1037 2 13 Led 5980-01-288-0188 3 1 Mini-Box (top section) 5999-00-971-8848 4 5 Tip Jack (assembled in figure D-109) 5935-00-683-7651 7 5 Terminal Lug 5940-00-283-5280 10 1 Tip Jack 5935-00-683-7651 13 25 Insulation Sleeving: 1 in. 5970-00-812-2974