TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download

Page 1068 of 1170

TM 9-2320-280-20-3 Change 1 D-95 Section II. ILLUSTRATED MANUFACTURING INSTRUCTIONS (Cont'd) INSTRUCTIONS: 1. Install four tiedown straps (11) in cable tie holders (10) and secure wires (2) to cable tie holders (10) with tiedown straps (11). 2. Install two loop clamps (4) on wires (2) of body harness connector and receptacle with screws (3), washers (8), and nuts (9). 3. Install two loop clamps (12) on wires (2) of engine harness connector and receptacle with screws (3), washers (8), and nuts (9). 4. Cut two 48-in. (1,219.2 mm) sections of conduit insulation (5). 5. Remove ten tiedown straps (7) from wires (2) of body harness connector and receptacle. 6. Position two sections of conduit insulation (5) over wires (2) of body harness connector and receptacle and secure with tape (6). 7. Cut two 54-in. (1,371.6 mm) sections of conduit insulation (13). 8. Remove twelve tiedown straps (7) from wires on engine harness connector and receptacle. 9. Position sections of conduit insulation (13) over wires (2) on engine harness connector and receptacle and secure with tape (6). Figure D-108. Terminal Strip Installation. ITEM MATERIALS NO. REQ’D DESCRIPTION NSN/PART NUMBER 3 4 Screw 5305-00-984-6210 4 2 Loop Clamp 5340-00-057-2904 5 2 Conduit Insulation: 48 in. 68240 6 AR Tape 7510-00-802-8311 8 4 Washer 5310-00-883-9384 9 4 Nut 5310-00-934-9758 11 4 Tiedown Strap 5975-00-074-2072 12 2 Loop Clamp 5434-00-724-7038 13 2 Conduit Insulation: 54 in. 68243