TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download
Page 1062 of 1170
TM 9-2320-280-20-3 Change 1 D-89 Section II. ILLUSTRATED MANUFACTURING INSTRUCTIONS (Cont'd) Figure D-104. Terminal Block Assemblies and Cable Tie Holder Installation. INSTRUCTIONS: 1. Using wire marker (7) and 6-in. and 7-in. terminal block assemblies, locate and mark sections as shown. 2. Install 6-in.and 7-in. terminal block assemblies in mini-box bottom section (5) with four screws (4), washers (9), and nuts (8). 3. Install four cable tie holders (2) in mini-box bottom section (5) with eight screws (3), washers (10), and nuts (11). 4. Install two non-metallic grommets (1) in holes A on mini-box bottom section (5). 5. Install two non-metallic grommets (6) in holes B on mini-box bottom section (5). ITEM MATERIALS NO. REQ’D DESCRIPTION NSN/PART NUMBER 1 2 Grommet, Non-metallic 5325-00-270-8890 2 4 Cable Tie Holder MB4A 3 8 Screw 5305-00-958-4353 4 4 Screw 5305-00-984-6210 5 1 Mini-box (bottom section) 5999-00-971-8848 6 2 Grommet, Non-metallic 5325-00-309-7164 7 1 Wire Marker 46F5981 8 4 Nut 5310-00-934-9758 9 4 Washer 5310-00-883-9384 10 8 Washer 5310-00-880-5976 11 8 Nut 5310-00-934-9753