TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download
Page 1058 of 1170
TM 9-2320-280-20-3 Change 1 D-85 INSTRUCTIONS: 1. Locate, mark, and drill 0.138-in. diameter hole (1) in mini-box bottom section (4) as shown. 2. Locate, mark, and drill two 1.250-in. diameter holes (2) in mini-box bottom section (4) as shown. 3. Locate, mark, and drill four 0.190-in. diameter holes (3) in mini-box bottom section (4) as shown. 4. Locate, mark, and drill fourteen 0.138-in. diameter holes (5) in mini-box bottom section (4) as shown. 5. Locate, mark, and drill two 0.750-in. diameter holes (6) in mini-box bottom section (4) as shown. 6. Install six non-metallic bumpers (9) on mount holes on mini-box bottom section (4) with washers (8), screws (7), and nuts (10) as shown. Figure D-100. Mini-box Bottom Section Drill Procedure (Cont’d).