TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download

Page 104 of 1170

10-49.1. THREE POINT SEATBELT BRACKETS REPLACEMENT (M996, M996A1, M997, M997A1, AND M997A2) 1. Remove two nuts (6), capscrews (4) and (5), four washers (3), and bracket (2) from body (7) and “B” pillar (1). 2. Remove capscrew (11), washer (10), and bracket (8) from mount (9). b. Installation 1. Install bracket (8) on mount (9) with washer (10) and capscrew (11). Tighten capscrew (11) to 90-95 lb-ft (122-129 Nm). 2. Install bracket (2) on body (7) and “B” pillar (1) with four washers (3), two capscrews (4) and (5), and nuts (6). Tighten capscrews (4) to 9-11 lb-ft (12-15 Nm) and capscrews (5) to 20-22 lb-ft (27-30 Nm). This task covers: a. Removal b. Installation a. Removal NOTE Left and right seatbelt bracket replacement procedures are basically the same. This procedure covers the left seatbelt bracket. INITIAL SETUP: Applicable Models M996, M996A1, M997, M997A1, M997A2 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Manual References TM 9-2320-280-24P Equipment Condition Three point seatbelt removed (para. 10-48.1). TM 9-2320-280-20-3 10-82.2 Change 1