TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download
Page 1023 of 1170
INSTRUCTIONS: TM 9-2320-280-20-3 Section II. ILLUSTRATED MANUFACTURING INSTRUCTIONS (Cont’d) Figure D-65. Protective Shield 6. 7. 1. 2. 3. 4. Cut aluminum sheet metal to size as shown. Locate, mark, and drill two 0.193-in. diameter holes in protective shield (1). Locate, mark, and drill three 0.203-in. diameter holes in protective shield (1). Make two 0.50-in. relief cuts in sides of protective shield (1). 5. Bend edges (90° bend along dotted lines) on protective shield (1). Remove all burrs and sharp edges. Paint protective shield (1) as required. Refer to TM 43-0139. D-50