TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 3 Download
Page 102 of 1170
TM 9-2320-280-20-3 10-49. THREE POINT SEATBELT BRACKETS REPLACEMENT This task covers: a. Front Seatbelt Bracket Removal c. Rear Seatbelt Bracket Removal b. Front Seatbelt Bracket Installation d. Rear Seatbelt Bracket Installation INITIAL SETUP: Applicable Models Manual References All models except M996, M996A1, M997, TM 9-2320-280-24P M997A1, M997A2 Equipment Condition Tools Three point seatbelt removed (para. 10-48). General mechanic’s tool kit: automotive (Appendix B, Item 1) NOTE Left and right seatbelt brackets replacement procedures are basically the same. This procedure covers the left seatbelt bracket. a. Front Seatbelt Bracket Removal 1. Remove four capscrews (3), washers (2), and upper bracket (1) from “B” pillar (4). 2. Remove four capscrews (6), washers (5), and lower bracket (7) from “B” pillar (4). b. Front seatbelt Bracket Installation 1. Install lower bracket (7) on “B” pillar (4) with four washers (5) and capscrews (6). Tighten capscrews (6) to 15-21 lb-n (20-29 N.m). 2. Install upper bracket (1) on “B” pillar (4) with four washers (2) and capscrews (3). Tighten capscrews (3) to 15-21 lb-ft (20-29 N.m). c. Rear Seatbelt Bracket Removal NOTE Left and right seatbelt brackets replacement procedures are basically the same. This procedure covers the right seatbelt bracket. 1. Remove two nuts (15), washers (14), capscrews (12), and washers (13) from bracket (10) and wheelhouse (16). 2. Remove two nuts (18), washers (17), capscrews (9), washers (8), and bracket (10) from wheelhouse (16). 3. Inspect turnbutton (11) for bends, corrosion, or damage. Replace if damaged, refer to para. 10-66 for rivet removal. d. Rear seatbelt Bracket installation 1. Install bracket (10) on wheelhouse (16) with two washers (8), capscrews (9), washers (17), and nuts (18). Tighten capscrews (9) to 43-60 Ib-ft (58-81 N.m). 2. Secure bracket (10) to wheelhouse (16) with two washers (13), capscrews (12), washers (14), and nuts (15). Tighten capscrews (12) to 43-60 lb-ft (58-81 Nom). 10-82