TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 2 Download
Page 916 of 953
9-14. RECEPTACLE MOUNTING BRACKET REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: Applicable Models All vehicles except M996, M996A1, M997, M997A1, M997A2, M1037, M1042 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Two locknuts (Appendix G, Item 79) Four assembled locknuts (Appendix G, Item 130) Manual References TM 9-2320-280-24P 1. Remove four assembled locknuts (9), capscrews (6), cover (5), and receptacle (1) from bracket (4). Discard assembled locknuts (9). NOTE • If bracket is held on to “D” beam with rivets, proceed to step 2. If not, proceed to step 3. • For instructions on removal of rivets, refer to para. 10-66. 2. Remove two rivets and bracket (4) from “D” beam (3). 3. Remove two locknuts (2) capscrews (8), washers (7), and bracket (4) from “D” beam (3). Discard locknuts (2). NOTE If bracket was held on to “D” beam with rivets, do step 1. If not, do step 2. 1. With a 0.3125-in. drill bit, enlarge existing rivet holes on bracket (4) and “D” beam (3). 2. Install bracket (4) on “D” beam (3) with two washers (7), capscrews (8), and locknuts (2). 3. Install receptacle (1) and cover (5) on bracket (4) with four capscrews (6) and assembled locknuts (9). b. Installation a. Removal TM 9-2320-280-20-2 Change 3 9-21