TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 2 Download
Page 842 of 953
TM 9-2320-280-20-2 8-11. REAR WHEEL TOE-OUT ALIGNMENT (Cont’d) c. Toe-out Adjustment 1. Loosen two locknuts (1) securing two clamps (3) on each adjusting sleeve (2). NOTE Toe-out can be increased or decreased by changing length of radius rods. A threaded sleeve is provided for this purpose. 2. Turn each adjusting sleeve (2) equally but in opposite directions. 3. Roll vehicle rearward then forward to original position. 4. Repeat toe-out check and adjustment procedures until correct adjustment is indicated. 5. Secure two clamps (3) on each adjusting sleeve (2) with two locknuts (1). Tighten locknuts (1). to 30 lb-ft (40 N m). FOLLOW-ON TASK: Operate vehicle (TM 9-2320-280-10) and check for pull or wander. 8-42