TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 2 Download
Page 836 of 953
TM 9-2320-280-20-2 8-10. FRONT WHEEL TOE-IN ALIGNMENT (Cont’d) c. Toe-in Adjustment 1. Loosen two locknuts (3) from clamps (1) on each adjusting sleeve (2). NOTE Toe-in can be increased or decreased by changing length of tie rods. A threaded sleeve is provided for this purpose. Both tie rods must be the same length ± 1/8 inch (3 mm) after adjustment. 2. Turn each adjusting sleeve (2) equally but in opposite directions. 3. Roll vehicle rearward then forward to original position. 4. Repeat toe-in check and adjustment procedures until correct adjustment is indicated. CAUTION Ensure bolt and nut on adjusting sleeve clamp nearest to geared hub is facing halfshaft. Bolt and nut on adjusting sleeve clamp nearest to frame must be facing away (180°) from stabilizer bar, to prevent damage to equipment. 5. Secure two clamps 30 lb-f-t (40 N·m). (1) on each adjusting sleeve (2) with two locknuts (3). Tighten locknuts (3) to 8-36