TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 2 Download
Page 775 of 953
7-24. LEFT PARKING BRAKE CABLE/MOUNTING BRACKET REPLACEMENT (Cont’d) TM 9-2320-280-20-2 7-60 Change 3 NOTE Perform step 1 if replacing parking brake cable mounting bracket. If not, proceed to step 2. 1. Install parking brake cable mounting bracket (4) and tailpipe hanger (6) on rear body mount (7) with two capscrews (5), four washers (3), and two nuts (1). NOTE Ensure clamp bracket (P/N 12342966) is installed on vehicle. 2. Install clamp bracket (34) on support bracket (14) with washer (31), capscrew (41), washer (33), and locknut (32). 3. Slide parking brake cable clamp (35) onto parking bracket cable assembly (22) and install cable clamp (35) on clamp bracket (34) with lockwasher (36) and capscrew (37). 4. Slide parking brake cable clamp (38) onto parking brake cable assembly (22) and install cable clamp (38) on clamp bracket (34) with capscrew (40), washer (39), and locknut (42). 5. Install parking brake cable clamp (12) on parking brake cable assembly (22) and install cable clamp (12) on parking brake cable mounting bracket (4) with washer (11), capscrew (13), and assembled locknut (10). 6. Install parking brake cable sleeve (9) on “C” beam (28) and parking brake cable (8) on equalizer bar (29) with retaining ring (30). CAUTION Ensure that the caliper cable bracket is secure with no signs of looseness and the lever is in contact with the caliper cable bracket stop. Damage to equipment and poor performance will result if not aligned properly. 7. Install parking brake cable sleeve (9) on rear caliper cable bracket (15) with cable retaining ring (16). 8. Install brake clevis (20) on rear caliper lever (17) with clevis pin (21), washer (19), and cotter pin (18). 9. Install parking brake cable assembly (22) on bracket (26) with clamp (23), capscrew (25), and lockwasher (24). 10. Install bracket (26) on bracket (14) with two capscrews (27). b. Installation