TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 2 Download

Page 656 of 953

TM 9-2320-280-20-2 6-10. GEARED HUB SIDE COVER REPLACEMENT This task covers: a. Removal c. Installation b. Cleaning and Inspection INITIAL SETUP: Tools Equipment Condition General mechanic’s tool kit: Wheel removed (para. 8-3). automotive (Appendix B, Item 1) General Safety Instructions Materials/Parts Drycleaning solvent is flammable and will not be Sealing compound (Appendix C, Item 46) used near an open flame. A fire extinguisher will Sealant (Appendix C, Item 38) be kept nearby when the solvent is used. Use only Drycleaning solvent, (Appendix C, Item 18) in well-ventilated places. Manual References TM 9-2320-280-10 TM 9-2320-280-24P NOTE Have drainage container ready to catch oil. Geared hub side cover replacement procedures are basically the same for front and rear covers. This procedure deals with the front side cover. a. Removal 1. Remove drainplug (5) from geared hub (1) and drain geared hub (1). 2. Install drainplug (5) in geared hub (1). 3. Remove eight capscrews (4), washers (3), and side cover (2) from geared hub (1). b. Cleaning and Inspection WARNING Drycleaning solvent is flammable and will not be used near an open flame. A fire extinguisher will be kept nearby when the solvent is used. Use only in well-ventilated places. Failure to do this may result in injury to personnel and/or damage to equipment. 1. Using drycleaning solvent, clean side cover (2). 2. Inspect side cover (2) for damage. If damaged replace. 1. Apply sealant (RTV) to side cover (2) and install side cover (2) on geared hub (1). 2. Apply sealing compound to capscrews (4) and install eight washers (3) and capscrews (4) on side cover (2). Tighten capscrews (4) to 15 lb-ft (20 N·m). 6-24