TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 2 Download
Page 654 of 953
6-9. HALFSHAFT MAINTENANCE (Cont’d) TM 9-2320-280-20-2 6-22.2 Change 3 e. Installation 1. Install halfshaft (9) into geared hub (4). 2. Apply sealing compound to halfshaft retaining capscrew (6) and install halfshaft (9) to geared hub (4) with lockwasher (5) and halfshaft retaining capscrew (6). Tighten halfshaft retaining capscrew (6) to 37 lb-ft (50 N•m). 3. Install washer (7) and access plug (8) into geared hub (4). Tighten access plug (8) to 8-13 lb-ft (11-18 N•m). NOTE Ensure all six capscrew holes in the rotor align with holes in output flange. 4. Apply sealing compound to six capscrews (3). Install halfshaft (9) to rotor (1) and output flange (10), with six lockwashers (2) and capscrews (3). Tighten capscrews (3) to 48 lb-ft (65 N•m). NOTE Perform steps 5 through 7 for rear halfshafts only. 5. Install parking brake cable (11) to caliper cable bracket (12) with retaining ring (13). CAUTION • Ensure lever is in contact with caliper cable bracket stop. Damage to equipment and poor performance will result if not aligned properly. • Ensure that the clevis and clevis pin are aligned in the lever. Do not move the lever to accommodate misadjusted clevis. Damage to equipment and poor performance may result. 6. Install parking brake clevis (17) to lever (14) with clevis pin (18), washer (16), and cotter pin (15). Check position of lever (13) and ensure it is in contact with caliper cable bracket stop (13.1). 7. If lever (14) is not in contact with caliper cable bracket stop (13.1), adjust rear dual service parking brake (para. 7-26).