TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 2 Download
Page 647 of 953
This task covers: a. Removal d. Assembly b. Disassembly e. Installation c. Cleaning and Inspection INITIAL SETUP: 6-9. HALFSHAFT MAINTENANCE Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Boot service kit (fixed) (Appendix G, Item 7) Boot service kit (plunged) (Appendix G, Item 7) Retaining ring (Appendix G, Item 231) Cotter pin (Appendix G, Item 12) Six lockwashers (Appendix G, Item 145) Lockwasher (Appendix G, Item 146) Drycleaning solvent (Appendix C, Item 18) Lithium grease (Appendix C, Item 25) Sealing compound (Appendix C, Item 41) Manual References TM 9-2320-280-24P Equipment Condition Wheel removed (para. 8-3). General Safety Instructions Drycleaning solvent is flammable and will not be used near an open flame. TM 9-2320-280-20-2 Change 3 6-17 1. Remove access plug (8) and washer (7) from geared hub (4). 2. Remove halfshaft retaining capscrew (6) and lockwasher (5) from halfshaft (9) and geared hub (4). Discard lockwasher (5). 3. Remove six capscrews (3), lockwashers (2), and halfshaft (9) from rotor (1) and output flange (10). Discard lockwashers (2). NOTE Perform steps 4 and 5 for rear halfshafts only. 4. Remove cotter pin (15), washer (16), and clevis pin (18) from parking brake clevis (17) and lever (14). Discard cotter pin (15). 5. Remove retaining ring (13) and disconnect cable (11) from caliper cable bracket (12). Discard retaining ring (13). a. Removal