TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 2 Download
Page 526 of 953
TM 9-2320-280-20-2 4-119. CONTROL BOX ELECTRICAL PLUG AND RECEPTACLE REPLACEMENT This task covers: a. Plug Removal c. Receptacle Removal b. Plug Installation d. Receptacle Installation INITIAL SETUP: Applicable Models Manual References M996, M996A1, M997, M997A1, M997A2 TM 9-2320-280-24P Tools Equipment Condition General mechanic’s tool kit: Battery ground cable disconnected (para. 4-73) automotive (Appendix B, Item 1) (receptacle only). a. Plug Removal 1. Turn and pull plug (4) from receptacle (3). 2. Remove two screws (5) from plug (4). Open plug (4) and ensure positive (10), negative (12), and ground (11) leads for plug (4) are properly installed. b. Plug Installation 1. Close plug (4) and install two screws (5) on plug (4). 2. Insert plug (4) on receptacle (3). c. Receptacle Removal NOTE For instructions on replacement of rivets, refer to para. 10-66. 1. Remove two rivets (6) and receptacle (3) from control box (1). Pull receptacle (3) away for access to leads (2). NOTE Prior to removal, tag leads for installation. 2. Loosen screw (8) and push shield (9) away for access to leads (2). 3. Remove two screws (7), and leads (2) from receptacle (3). d. Receptacle Installation 1. Install two leads (2) on receptacle (3) with two screws (7). Position shield (9) over screws (7) and tighten screw (8). 2. Install receptacle (3) on control box (1) with two rivets (6). 4-280