TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 2 Download
Page 464 of 953
4-102. INTERIOR LIGHTING HARNESS ASSEMBLY REPLACEMENT (M996, M996A1) (Cont’d) TM 9-2320-280-20-2 4-226 Change 3 24. Remove four screws (7) from cover (6) and body (15). 25. Remove nut (3), screw (10), clamp (11), and cover (6) from light harness (14). 26. Remove grommet (9) from cover (8). 27. Disconnect two harness leads (5) from light leads (4). 28. Remove ten screws (13) from cover (8) and body (15). Lower cover (8) to allow access to harness (1). 29. Disconnect six harness leads (2) from light harness leads (12). Remove harness cover (8). CAUTION Use care when removing harness. Failure to do so will cause damage to harness. 30. Remove harness (1) from body (15). CAUTION Use care when routing harness. Failure to do so will cause damage to harness. 1. Route harness (1) through vehicle in approximate mounting location. 2. Position harness cover (8) over harness (1) and connect six harness leads (2) to light harness leads (12). Install cover (8) on body (15) with ten screws (13). 3. Connect two harness leads (5) to light leads (4). 4. Install grommet (9) on cover (8). 5. Install clamp (11) and light harness (14) on cover (6) with screw (10) and nut (3). 6. Install cover (6) on body (15) with four screws (7). 7. Install six clamps (16) and harness (1) on body (18) with six screws (17). b. Installation