TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 2 Download
Page 454 of 953
4-101. INTERIOR LIGHTING HARNESS ASSEMBLY REPLACEMENT (M997, M997A1, M997A2) (Cont’d) TM 9-2320-280-20-2 4-216 Change 3 22. Remove four screws (7) from cover (6) and body (14). 23. Remove nut (3), screw (10), and cover (6) from two clamps (11) and light harnesses (11.1). 24. Disconnect four harness leads (5) from light leads (4). 25. Remove ten screws (13) from cover (8) and body (14). Lower cover (8) to allow access to harness (1). 26. Disconnect six harness leads (2) from light harness leads (12). Remove grommet (9) and harness cover (8). CAUTION Use care when removing harness. Failure to do so will cause damage to harness. 27. Remove harness (1) from body (14). CAUTION Use care when routing harness. Failure to do so will cause damage to harness. 1. Route harness (1) through vehicle in approximate mounting location. 2. Position harness cover (8) over harness (1) and connect six harness leads (2) to light harness leads (12). Install grommet (9) and cover (8) to body (14) with ten screws (13). 3. Connect four harness leads (5) to light leads (4). 4. Install two clamps (11) and light harnesses (11.1) on cover (6) with screw (10) and nut (3). 5. Install cover (6) on body (14) with four screws (7). 6. Install six clamps (15) on harness (1) and body (17) with six screws (16). b. Installation