TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 2 Download
Page 44 of 953
TM 9-2320-280-20-2 3-13. AIR CLEANER FILTER ELEMENT SERVICING (Cont'd) WARNING Compressed air used for cleaning purpose will not exceed 30 psi (207 kPa). Use only with effective chip guarding and personnel protective equipment (goggles/shield, gloves, etc.). 1. 2. 3. 4. 5. 6. 7. Hold nozzle at least one inch away from element (1) and direct compressed air against clean side of element (1) (in direction opposite to normal air flow). Move air stream up and down length of pleats until you can not see dust being blown out. Prepare a solution of five gallons warm water (80-110° F (26.7-43.3° C)) and approximately one cup of non-sudsing detergent in a container large enough to submerge the element (1). Never use gasoline or solvents of any kind to clean elements. Immerse the element (1) completely in the cleaning solution. Swish for two minutes. Soak the element in the cleaning solution for 15 to 20 minutes, then swish it around again to remove contaminants. Remove the element (1) from the solution and let it drain. Rinse the element with cool water (35-80° F (1.7-26.7° C)) from clean side to dirty side (in direction opposite to normal air flow) with a gentle stream of water (no more than 40 psi (275.8 kpa)). If the clean side was contaminated during the soak cycle, rinse the element from both sides. Air dry the element (1) at normal room temperature until completely dry. Usually overnight is ade- quate, but temperature and humidity will effect drying time. If you use circulating air, do not exceed 180° F (82.2° C). Do not use compressed air to speed drying time, you will damage your element. Reinspect the element (1) and discard if damaged. If it checks out O.K., mark the date of cleaning on it. e. Installation 1. Remove screen or rag from housing opening. 2. Install filter element (1) into air cleaner assembly (6) and on stud (5) with nut and washer assembly (7). Tighten nut and washer assembly (7) to 20-40 lb-in (2-4 N-m). CAUTION When cover clamp is secured to end of filter body assembly, ensure the clamp bolt is between the three and six o’clock position to prevent damaging hood when hood is closed. 3. Install cover (3) and gasket (4) on air cleaner assembly (6) with ring clamp (2) as shown. Tighten bolt (8) to 35-40 lb-in (3-4 N-m). 3-24