TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 2 Download
Page 344 of 953
TM 9-2320-280-20-2 4-106 Change 2 4-65. DIRECTIONAL SIGNAL CONTROL REPLACEMENT a. Removal 1. Loosen connector nut (6) and remove connector plug (7) from directional signal control (4). 2. Remove four screws (2) and directional signal control (4) from bracket (1). INITIAL SETUP: Applicable Models M997A2, M1025A2, M1035A2, M1043A2, M1045A2, M1097A2, M1123 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Manual References TM 9-2320-280-10 TM 9-2320-280-24P Equipment Condition Battery ground cables disconnected (para. 4-73). 1. Place lever (5) in HAZARD position. 2. Install directional signal control (4) on bracket (1) with four screws (2). Do not tighten screws (2). 3. Rotate steering wheel ensuring pin (3) mates with directional signal control (4) and tighten screws (2) to 22-26 lb-in. (2.5-2.9 N•m). 4. Install connector plug (7) on directional signal control (4) and tighten connector nut (6). b. Installation This task covers: a. Removal b. Installation FOLLOW-ON TASKS: • Connect battery ground cables (para. 4-73). • Check directional signal control lamp for proper operation (TM 9-2320-280-10).