TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 2 Download
Page 328 of 953
4-55. SIDE MARKER LIGHT ASSEMBLY REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Four locknuts (Appendix G, Item 74) (front only) Manual References TM 9-2320-280-10 TM 9-2320-280-24P Equipment Condition • Battery ground cable disconnect (para. 4-73). • Hood raised and secured (front side marker only) (TM 9-2320-280-10). NOTE Procedures to remove and install the front and rear side marker light assemblies are basically the same for all models. Front marker lights have locknuts, rear marker lights have plain nuts. This procedure is for the left front side marker for basic and A1 models. 1. Remove four screws (1), washers (2), and close-off cover (3) from hood (4). 2. Disconnect lead 489 (14) from hood wiring harness (15). 3. Remove two screws (13), lens (11), and door (12) from side marker light (9) 4. Remove four screws (10), washers (6), locknuts (5), ground 92 (7), gasket (8), and side marker light (9) from hood (4). Discard locknuts (5). 1. Install gasket (8), side marker light (9), and ground 92 (7) on hood (4) with four screws (10), washers (6), and locknuts (5) ensuring ground 92 (7) is under washers (6). 2. Install lens (11) and door (12) on side marker light (9) with two screws (13). 3. Connect lead 489 (14) to hood wiring harness (15). 4. Install close-off cover (3) to hood (4) with four washers (2) and screws (1). b. Installation a. Removal TM 9-2320-280-20-2 4-90 Change 3